Motion Pro Handlebar Stop/Start Switch

Motion Pro Handlebar Stop/Start Switch

Details
- Required for installation of Rev2 or Revolver Throttle Kit on bikes with ignition and starter switches in stock throttle assembly
- Fits 7/8" bars (22,2 mm)
- Extra narrow design is only 26 mm wide
- Push In/Out engine switch
- Momentary 2 pole starter switch
- Starter switch has 2 separate circuits, one normally open, one normally closed for street bikes that use a headlight/starter cutoff
- 550 mm long wiring harness with brake light switch circuit wiring
- Brake light circuit wiring pigtail 120 mm long with female spade connectors
- Stainless steel Screws and internal rubber pad positions switch handlebar securely without drilling holes
- Wiring harness has bare, tinned wires without connector for easy installation of OE connector body
- Made in Italy by Domino